6. Projectile Motion

6. Projectile Motion

Basic Concept

1. Projectile motion is a form of motion in which an object or particle (called a projectile) is thrown with some initial velocity near the earth's surface, and it moves along a curved path under the action of gravity alone.
2. It is an example of two dimensional motion with constant acceleration.
3. If F is constant then a is constant and when force is oblique direction with initial velocity , the result is parabolic path.
   
4. Projectile motion is considered as two simultaneous motion in mutually perpendicular directions which are completely independent from each other i.e., horizontal motion and vertical motion
   

Projectile thrown at an angle with horizontal

So we have seen our basics let us now learn the projectile motion in little more detail about Projectile thrown at an angle with horizontal. There are certain approximate assumptions we make while studying projectile motion and they are

1. We ignore the frictional resistance due to air.
2. The effect due to rotation of earth and the curvature of earth is negligible.
3. The acceleration due to gravity is constant in magnitude and direction at all points during the motion of projectile.

• Projectile motion is a special case of motion in two dimension when acceleration of particle is constant in both magnitude and direction.
• An object is referred as projectile when it is given an initial velocity which subsequently follows a path determined by gravitational forces acting on it. For example bullet fired from the rifle javelin thrown by the athlete etc.
• Path followed by a projectile is called its trajectory.
• In this section we will study the motion of projectile near the earth surface. We would be neglecting the air resistance.
• Acceleration acting on a projectile is constant which is acceleration due to gravity (g=9.81 m/s) directed along vertically downward direction.
• We shall treat the projectile motion in a Cartesian co-ordinates system taking y axis in vertically upwards direction and x axis along horizontal directions
• Now x and y components of acceleration of projectile is
  ax=0 and ax=0
  Since acceleration in horizontal direction is zero, this shows that horizontal component of velocity is constant and vertical motion is simply a case of motion with constant acceleration.
• Suppose at time t=0 object is at origin of co-ordinate system and velocity components v0xand v0y. From above components of acceleration are ax=0 and ay=−g. From equation (11) and (12) in the previous section components of position and velocity are
  x=v0xt                                          (14a)
  vx=v0x                                           (14b)
  and vy=v0y−gt                                          (15b)
  y=v0y−12gt2                                          (15a)
• Figure below shows motion of an object projected with velocity v0 at an angle θ0 .
  
  
   
• In terms of initial velocity v0 and angle θ0 components of initial velocity are
  v0x=v0cosθ0                                          (16a)
  v0y=v0sinθ0                                           (16b)
• Using these relations in equation 14 and 15 we find
  x=(v₀cosθ₀)t                                          (17a)
  y=(v₀sinθ₀)t-(1/2)gt²                                           (17b)
  v_x=v₀cosθ₀                                           (17c)
  v_y=v₀sinθ₀-gt                                           (17d)
  Above equations describe the position and velocity of projectile as shown in fig 5 at any time t.

(A)Equation of Path of projectile(Trajectory)

• From equation 17a
  t=x/v₀cosθ₀ 
  now putting this value of t in equation 17b,we find
  y=(tanθ₀ )x-[g/2(v₀cosθ₀)²]x²                                           (18)
  In equation (18),quantities θ₀,g and v₀ are all constants and equation (18) can be compared with the equation
  y=ax-bx²
  where a and b are constants
• This equation y=ax-bx² is the equation of the parabola.From this we conclude that path of the projectile is a parabola as shown in figure 5

B) Time of Maximum height

• At point of maximum height v_y=0.Thus from equation (17d)
  v_y=v₀sinθ₀-gt 
  0=v₀sinθ₀-gt -
  or t_m=v₀sinθ₀/g                                          (19)
• Time of flight of projectile which is the total time during which the projectile is in flight can be obtained by putting y=0 because when projectile reaches ground ,verical distance travelled is zero.This from equation (17b)
  
  t_f=2(v₀sinθ₀)/g                                          (20)
  or
  t_f=2t_m
• Maximum height reached by the projectile can be calculated by substituting t=t_m in equation 17b
  y=H_m=(v₀sinθ₀)(v₀sinθ₀/g)-(g/2)(v₀sinθ₀/g)²
  or
  H_m=v₀²sin²θ₀/2g                                          (21)

(C) Horizontal Range of Projectile

• Since acceleration g acting on the projectile is acting vertically ,so it has no component in horizontal direction.
• So, projectile moves in horizontal direction with a constant velocity v₀cosθ₀. So range R is
  R=OA=velocity x time of flight
  
   
• Maximum range is obtained when sin2θ₀=1 or θ₀=45⁰. Thus when θ₀=45⁰ maximum range achieved for a given initial velocity is (v₀)²/g.

Impact of air resistance on the motion of the projectile.

So far we have assumed that air resistance has no effect on the motion of the projectile.Now we know Friction, force due to viscosity, air resistance are all dissipative forces. In the presence of any of such forces opposing motion, any object will lose some part of its initial energy and consequently, momentum too. Thus, a projectile that traverses a parabolic path would certainly show deviation from its idealised trajectory in the presence of air resistance. It will not hit the ground with the same speed with which it was projected from it. In the absence of air resistance, the x-component of the velocity remains constant and it is only the y-component that undergoes a continuous change. However, in the presence of air resistance, both of these would get affected. That would mean that the range would be less than the one given above Maximum height attained would also be less than that predicted by above. The mathematics of the motion with air resistance is quite complicated (especially if you consider the change in the shape and/or surface of a projectile and the variation of the density of the air with height) but the following diagrams try to simplify things by showing generally how air resistance affects trajectory of a projectile.


When we use a phrase like ?neglect air resistance?, we imply that the change in parameters such as range, height etc. is much smaller than their values without air resistance. The calculation without air resistance is much simpler than that with air resistance